™
Silentio
1.5L kettle with Quiet Boil Technology
Instruction Booklet
KE7450
Please read these instructions carefully
and retain for future reference.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR YOUR SUNBEAM
KETTLE.
• Always operate the kettle on a flat, level
surface.
• Boiling water will scald. Do not leave a boiling
or hot kettle near or where children
may touch it.
• Do not leave the power cord near the edge of a
bench top where children may touch or pull it.
• Boiling water may be ejected, if overfilled.
• Do not open lid while water is boiling.
• Do not operate the kettle without water.
• Always turn the power off and unplug the cord
while the kettle is NOT in use.
™
• Your Silentio kettle must only be used with
the power base supplied.
• Do not move kettle while switched on.
Sunbeam is very safety conscious when
designing and manufacturing consumer products,
but it is essential that the product user also exercise
care when using an electrical appliance. Listed
below are precautions which are essential for the
safe use of an electrical appliance:
• Do not use an appliance for any purpose other
than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
• Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• Read carefully and save all the instructions
provided with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove by
grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug when the
appliance is not in use and before cleaning.
• Do not use your appliance with an extension cord
unless this cord has been checked and tested by
a qualified technician or service person.
• Always use your appliance from a power outlet of
the voltage (A.C. only) marked on the appliance.
• This appliance is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for their
safety.
• Do not operate any electrical appliance with a
damaged cord or after the appliance has been
damaged in any manner. If damage is suspected,
return the appliance to the nearest Sunbeam
Appointed Service Centre for examination, repair
or adjustment.
• For additional protection, Sunbeam recommend
the use of a residual current device (RCD)
with a tripping current not exceeding 30mA in
the electrical circuit supplying power to your
appliances.
• Do not immerse the appliance in water or any
other liquid unless recommended.
• Appliances are not intended to be operated by
means of an external timer or separate remote
control system.
• This appliance is intended to be used in
household and similar applications such as: staff
kitchen areas in shops, offices and other working
environments; farm houses; by clients in hotels,
motels and other residential type environments;
bed and breakfast type environments.
• Children should be supervised to ensure that they
do not play with the appliance.
• The temperature of accessible surfaces may be
high when the appliance is operating.
• Never leave an appliance unattended while
in use.
If you have any concerns regarding the performance and use of your appliance,
Ensure the above safety precautions are understood.
1
Features of your Silentio™ Kettle
Stylish brushed stainless steel design
Long life stainless steel to suit any kitchen
décor.
2400 watt concealed element with quiet boil
technology
The fast boil 2400 watt element is concealed
in the base of the kettle for longer element
life. The textured floor surface reduces the
noise level during heating and reduces the
build up of minerals.
360 degree cordless power base
Designed to allow you to place the kettle on
the base in any direction.
Removable mesh filter
Keeps the water clean of any foreign matter
and is removable or easy cleaning.
2
3-Way Safety System.
1 – Automatically switches the kettle off after boiling.
2 – Cuts out for boil-dry production.
3 – Shuts down in case of overheating.
Hinged locking lid
Opens at the push of a button for one-handed
use and easy filling at the tap.
Twin water level gauges
Full length water gauge indicates the volume
of water in the kettle up to 1.5L. The two
gauges make the kettle convenient to use for
both left and right handed users.
Illuminated ON/OFF switch with auto cut-off
Lights up to indicate that the kettle is on and
heating. Switches the kettle off automatically
after boiling.
Cord storage facility
Excess cord can be wound around the cord
storage facility underneath the power base.
3
Quiet Boil Technology
The Sunbeam Silentio™ Kettle features new
Quiet Boil Technology that makes boiling water
a peaceful practice.
The quiet boil technology incorporates a
4mm thick, aluminium diffuser plate located
between the heating element and the kettle
floor, ensuring an even spread of heat
distribution into the water. The kettle floor is
also equipped with two textures – a smooth
polished, reflective surface and sand-blasted
textured area – which disperses the heat and
bubbles. The combination of the modified
element diffuser plate and selective texturing
gives rise to a significant noise reduction
throughout the whole boiling process.
Maintaining the Quiet Boil Technology.
Mineral deposits in tap water solidify when
the water is heated; lime scale may be white,
coloured, even rusty-looking and is normally
visible but phosphate scale isn’t generally
visible although may cause the water to
appear cloudy when heated.
Regular use of the kettle can lead to the
build-up of these minerals which reduces the
effectiveness of the Quiet Boil technology as
well as the performance of the kettle.
It is important to descale your kettle regularly
to maintain the Quiet Boil technology and to
prolong the life of the kettle.
4
Using your Silentio™ Kettle
Before using your kettle.
6.Lift the kettle from the power base and
pour the water.
NOTE: Use caution when pouring the water
from your kettle, as boiling water will scald.
It is recommended that you clean your kettle
before use by filling the kettle with water, up
to the maximum level indicator, boil and
discard.
7.The kettle may be stored on the power
base while not in use. The kettle will not
re-boil until the ON/OFF switch is pressed
downward.
NOTE: Ensure the power is turned off at the
power outlet when the kettle is not in use.
Should you accidentally allow the kettle to
operate without water, boil-dry protection will
automatically switch it off. If this occurs,
allow the kettle to cool before filling with
cold water and re-boiling.
Using your kettle.
1.To fill the kettle, remove it from the power
base and lift the lid, by pressing the button
on the handle. Alternatively, the kettle may
be filled through the pouring spout.
2.Fill the kettle with the desired amount of
water. Always fill the kettle between the
minimum and maximum marks. Too little
water will result in the kettle switching off
before the water has boiled.
Cord Storage Facility.
NOTE: Do not fill the kettle over the maximum
level, as water may spill out of the spout
when boiling.
3.Push the lid closed firmly until it locks into
position.
Excess cord can be stored by winding the
cord around the storage facility underneath
the power base.
4.Place the kettle on the power base and
connect the plug into a 230/240 Volt AC
power outlet. Turn the power ON.
5.Press the ON/OFF button downwards at the
base of the kettle. The ON/OFF button will
illuminate to indicate the kettle is heating.
The kettle will switch off automatically
once the water has boiled.
360° power base
NOTE: Ensure that the ON/OFF switch is clear
of obstructions and the lid is firmly closed.
The kettle will not turn off if the ON/OFF
switch is constrained or if the lid is left open.
Do not remove the kettle from the power base
while water is heating.
5
Sunbeam’s 3-Way
Safety System
Safety is a major consideration in the
design of a Sunbeam kettle. This is why we
have developed our 3-Way Safety System,
which ensures that your kettle will:
3. Shut-down in case of overheating.
In the event of overheating, the kettle will
automatically shut down to prevent further
damage. Should this occur, take your kettle
to a Sunbeam Service Centre or Appointed
Service Agent.
1. Automatically switch off after boiling.
For convenience, safety and energy
efficiency, your Sunbeam kettle will
automatically switch off after boiling.
2. Cut-out for boil-dry protection.
If the kettle is operated without water, it
will automatically cut-out, preventing any
damage to the element.
If this occurs, allow the kettle to cool
before filling with cold water and
re-boiling.
6
Care and Cleaning
Always disconnect the kettle from the power
outlet before cleaning.
Never immerse the kettle switch area, cord or
power base in water, or allow moisture to
come into contact with these parts.
To clean the stainless exterior
The stainless steel surface may be wiped over
with a damp cloth and polished with a soft
dry cloth.
CAUTION: Do not use chemicals, steelwool, or
abrasive cleaners to clean the outside of the
kettle, as these will scratch the stainless
steel surface.
Descale Your Kettle Regularly.
Mineral deposits in tap water solidify when
the water is heated; lime scale may be white,
coloured, even rusty-looking and is normally
visible but phosphate scale isn’t generally
visible although may cause the water to
appear cloudy when heated. This may cause
the interior of the water gauge to discolour,
reduce the effectiveness of the Quiet Boil
technology, cause overheating, trigger the
boil-dry cut-out mechanism or even reduce
the kettle’s life.
To clean the mesh filter.
Press the button on the handle to open the
hinged lid. Grasp the top of the mesh filter
and pull upwards to remove. Wash in warm
soapy water and dry thoroughly before
replacing in the kettle.
Cleaning the concealed heating element
This kettle features a non-corrosive stainless
steel heating element. Over time, scale may
build up on the concealed element inside the
kettle, causing discolouration that may have
the appearance of rust. Be assured this is not
rust. If this occurs clean with a green
Even in soft water areas it is important to
descale your kettle regularly to help
maintains its lifecyle.
NOTE: Failure to descale products regularly
can be deemed as negligent handling and
any faults caused by mineral build up will
not be covered by the Sunbeam 12 Month
Guarantee.
®
Scotchbrite scourer or similar and a suitable
abrasive cleaning cream. Rinse and clean
thoroughly with tap water before using your
kettle again.
To remove this build-up, use Sunbeam Liquid
Descaler, a simple to use, non-toxic cleaner
available from Sunbeam Appointed Service
Agents.
Alternatively:
1.Fill the kettle with 3 cups of white vinegar
and the remainder with water and allow to
stand overnight. DO NOT BOIL.
2.Empty the solution from the kettle. Any
stains remaining inside the spout can be
removed by rubbing with a damp cloth. Fill
the kettle with clean water, bring to boil
and then discard the water. Repeat and the
kettle will then be ready to use.
7
Notes
12 Month Replacement Guarantee
In the unlikely event that this appliance develops any malfunction
within 12 months of purchase (3 months commercial use) due to
faulty materials or manufacture, we will replace it for you
free of charge.
Should you experience any difficulties with
your appliance, please phone our customer
service line for advice on 1300 881 861 in
Australia, or 0800 786 232 in New Zealand.
Alternatively, you can send a written claim
to Sunbeam at the address listed below.
On receipt of your claim, Sunbeam will
seek to resolve your difficulties or, if the
appliance is defective, advise you on how
to obtain a replacement or refund.
In Australia you are entitled to a
replacement or refund for a major failure and
for compensation for any other reasonably
foreseeable loss or damage. You are also
entitled to have the goods repaired or
replaced if the goods fail to be of acceptable
quality and the failure does not amount to
a major failure.
Should your appliance require repair or
service after the guarantee period, contact
your nearest Sunbeam service centre.
Your Sunbeam 12 Month Replacement
Guarantee naturally does not cover misuse
or negligent handling and normal wear and
tear.
For a complete list of Sunbeam’s authorised
service centres visit our website or call:
Australia
Similarly your 12 Month Replacement
Guarantee does not cover freight or any other
costs incurred in making a claim. Please
retain your receipt as proof of purchase.
1300 881 861
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
The benefits given to you by this guarantee
are in addition to your other rights and
remedies under any laws which relate to the
appliance.
New Zealand
0800 786 232
26 Vestey Drive, Mt Wellington
Auckland, New Zealand
Our goods come with guarantees that cannot
be excluded under the Australian Consumer
Law and under the New Zealand Consumer
Guarantees Act.
Need help with your appliance?
Contact our customer service team or visit
our website for information and tips on
getting the most from your appliance.
In Australia
Or call 1300 881 861
In New Zealand
Or call 0800 786 232
is a registered trademark.
‘Silentio’ is a registered trademark of Sunbeam Corporation.
Made in China.
Due to minor changes in design or otherwise,
the product may differ from the one shown in this leaflet.
© Copyright. Sunbeam Corporation Limited 2002.
ABN 45 000 006 771
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
Unit 3, Building D
26 Vestey Drive
Mt Wellington Auckland
New Zealand
Sunbeam Corporation is a division of GUD Holdings Ltd.
03/12
|